Все аналоги
Полный отчётТехнические параметры
| Питание | |
|---|---|
| Auxiliary voltage (output) | U AUX | 24 V DC ± 15 % PELV |
| Current loading capacity | ≤ 120 mA (signal current + actuator supply) from AS-Interface; overload and short-circuit protected ≤ 700 mA (signal current + actuator supply) from external bulk power supply U AUX , overload and short-circuit protected |
| Rated operating current | I e | ≤ 75 mA (without outputs) / max. 200 mA |
| Rated operating voltage | U e | 26.5 ... 31.6 V from AS-Interface |
| Short-circuit current | voltage output: max. 22 mA |
| Supply | from AS-Interface (switch position INT, default settings) or auxiliary voltage U EXT (switch position EXT) |
| Характеристики по постоянному и переменному току | |
| Accuracy | 0.15 % of full-scale value |
| Noise immunity | EN 61000-6-2:2005, EN 61326-1:2006, EN 62026-2:2013 |
| Resolution | Voltage output: 3 mV Current output: 6 µA |
| Условия эксплуатации и корпус | |
| Ambient temperature | -25 ... 60 °C (-13 ... 140 °F) |
| Height | 35 mm |
| Height 35 mm Diameter 85 mm | Height | 35 mm | Diameter | 85 mm |
| Housing PBT PC Mounting screw Stainless steel 1.4305 / AISI 303 | Housing | PBT PC | Mounting screw | Stainless steel 1.4305 / AISI 303 |
| Mounting | Mounting plate |
| Mounting screw | Stainless steel 1.4305 / AISI 303 |
| Storage temperature | -25 ... 85 °C (-13 ... 185 °F) |
| Temperature influence | 1 µA/K or 0,3 mV/K |
| Другое | |
| Altitude | ≤ 2000 m above MSL |
| AS-Interface | EN 62026-2:2013 |
| AS-Interface specification | V3.0 |
| Climatic conditions | For indoor use only |
| Connection | AS-Interface/U AUX : cable piercing method, flat cable yellow/flat cable black Outputs: M12 round connector |
| Degree of protection | EN 60529:2000 |
| Diameter | 85 mm |
| Directive 2014/30/EU | EN 62026-2:2013 |
| Directive 2014/30/EU EN 62026-2:2013 | Directive 2014/30/EU | EN 62026-2:2013 |
| Emitted interference | EN 61000-6-4:2007 |
| Fieldbus standard | EN 62026-2:2013 |
| Housing | PBT PC |
| ID1 code | F |
| ID2 code | 6 |
| ID code | 3 |
| IO code | 7 |
| IO code 7 ID code 3 ID1 code F ID2 code 6 | IO code | 7 | ID code | 3 | ID1 code | F | ID2 code | 6 |
| LED ANALOG | Status of output signal; yellow LED Yellow: Output value within range Yellow flashing: lead breakage (on current output) or output value out of range |
| LED AS-i/FAULT | Status display; multi-colour LED Green: normal operation Red: communication fault Flashing yellow/red: address 0 Flashing green/red: peripheral fault |
| LED AUX | ext. auxiliary voltage U AUX ; dual LED green/red green: voltage OK red: reverse voltage |
| LED INT/EXT | status display output supply; LED green green: output supply from AS-Interface off: output supply from auxiliary voltage |
| Load | voltage output: min. 1 kΩ current output: max. 600 Ω |
| Mass | 200 g |
| Node type | Standard node |
| Number/Type | 4 analog outputs Current: 0 ... 20 mA Voltage: 0 ... 10 V |
| Pollution degree | 3 |
| Profile | S-7.3.6 |
| Protection class | III |
| Relative humidity | 85 % , non-condensing |
| Required gateway specification | ≥ V2.1 |
| Surge protection | U AUX , U in : Over voltage category III, safe isolated power supplies (PELV) |
| Tightening torque, cable gland | 0.4 Nm |
| Tightening torque, housing screws | 1.8 Nm |
| UL File Number | E223772 |
Изображения
Документы
К этому компоненту пока не привязаны документы.