Все аналоги
Полный отчётТехнические параметры
| Питание | |
|---|---|
| Auxiliary voltage (output) | U AUX | 24 V DC ± 15 % PELV |
| Current | 4 A total OUT 1, OUT 2: 2 A per output OUT 3: 1.5 A |
| Current loading capacity | ≤ 180 mA (T B ≤ 40 °C), ≤ 140 mA (T B ≤ 60 °C), short-circuit protected |
| Input current | ≤ 9 mA (limited internally) |
| Rated operating current | I e | ≤ 40 mA (without sensors) / max. 240 mA |
| Rated operating voltage | U e | 26.5 ... 31.6 V from AS-Interface |
| Supply | from AS-Interface |
| Voltage | 21 ... 31 V |
| Характеристики по постоянному и переменному току | |
| Noise immunity | EN 61000-6-2:2005 |
| Условия эксплуатации и корпус | |
| Ambient temperature | -25 ... 60 °C (-13 ... 140 °F) |
| Height | 71 mm |
| Height 71 mm Width 90 mm Length 102 mm | Height | 71 mm | Width | 90 mm | Length | 102 mm |
| Mounting | DIN rail or screw mounting |
| Storage temperature | -25 ... 85 °C (-13 ... 185 °F) |
| Другое | |
| 0 (unattenuated) | ≤ 3 mA |
| 0 (unattenuated) ≤ 3 mA 1 (attenuated) ≥ 5 mA | 0 (unattenuated) | ≤ 3 mA | 1 (attenuated) | ≥ 5 mA |
| 1 (attenuated) | ≥ 5 mA |
| Altitude | ≤ 2000 m above MSL |
| AS-Interface | EN 62026-2:2013 |
| AS-Interface specification | V3.0 |
| Climatic conditions | For indoor use only |
| Connection | cable piercing method or terminal compartment yellow flat cable/black flat cable or standard round cable inputs/outputs:M12 x 1.5 cable glands and cage tension spring terminals |
| D0 | IN1 OUT1 |
| D0 IN1 OUT1 D1 IN2 OUT2 D2 IN3 OUT3 D3 IN4 - | D0 | IN1 OUT1 | D1 | IN2 OUT2 | D2 | IN3 OUT3 | D3 | IN4 - |
| D1 | IN2 OUT2 |
| D2 | IN3 OUT3 |
| D3 | IN4 - |
| Data bits (function via AS-Interface) | Input Output |
| Degree of protection | EN 60529:2000 |
| Directive 2014/30/EU | EN 62026-2:2013 |
| Directive 2014/30/EU EN 62026-2:2013 | Directive 2014/30/EU | EN 62026-2:2013 |
| Emitted interference | EN 61000-6-4:2007 |
| Fieldbus standard | EN 62026-2:2013 |
| Housing | PA 6 GF30 |
| Housing PA 6 GF30 | Housing | PA 6 GF30 |
| ID1 code | 7 |
| ID2 code | 0 |
| ID code | A |
| Input | EN 61131-2:2007 |
| IO code | 7 |
| LED AUX | ext. auxiliary voltage U AUX ; LED green |
| LED IN | switching state (input); 4 LED yellow |
| LED OUT | Switching state (output); 3 LED yellow |
| LED PWR/FAULT | dual LED green/red green: AS-Interface voltage red: communication error or address 0 green/red flashing: overload sensor supply or outputs |
| Length | 102 mm |
| Mass | 350 g |
| Node type | A/B node |
| Number/Type | 4 inputs for 2- or 3-wire sensors (PNP), DC |
| P0 | not used |
| P0 not used P1 not used P2 not used P3 not used | P0 | not used | P1 | not used | P2 | not used | P3 | not used |
| P1 | not used |
| P2 | not used |
| P3 | not used |
| Parameter bits (programmable via AS-i) | function |
| Pollution degree | 3 |
| Profile | S-7.A.0 |
| Protection class | III |
| Relative humidity | 85 % , non-condensing |
| Required gateway specification | ≥ V2.1 |
| Surge protection | U AUX , U in : Over voltage category III, safe isolated power supplies (PELV) |
| Switching point | according to DIN EN 61131-2 (Type 2) |
| Tightening torque, housing screws | 0.8 Nm |
| UL File Number | E223772 |
| Width | 90 mm |
Изображения
Документы
К этому компоненту пока не привязаны документы.