Все аналоги
Полный отчётТехнические параметры
| Питание | |
|---|---|
| No-load supply current | I 0 | ≤ 20 mA |
| Off-state current | I r | 0 ... 0.5 mA |
| Operating current | I L | 0 ... 200 mA |
| Operating voltage | U B | 10 ... 60 V DC |
| Operating voltage indicator | LED, green |
| Voltage drop | U d | ≤ 2 V |
| Характеристики по постоянному и переменному току | |
| Switching frequency | f | 0 ... 200 Hz |
| Условия эксплуатации и корпус | |
| Ambient temperature | -40 ... 85 °C (-40 ... 185 °F) |
| Height | 40 mm |
| Height 40 mm Width 40 mm Length 118 mm | Height | 40 mm | Width | 40 mm | Length | 118 mm |
| Другое | |
| Actual operating distance | s r | 18 ... 22 mm typ. 20 mm |
| Assured operating distance | s a | 0 ... 16.2 mm |
| CCC approval | Certified by China Compulsory Certification (CCC) |
| Connection type | screw terminals |
| Core cross section | up to 2.5 mm 2 |
| Degree of protection | IP68 / IP69K |
| Diagnostic Coverage (DC) | 0 % |
| E1 Type approval | 10R-04 |
| Fire protection | requirements of hazard level 1 to 3 (HL1 - HL3) according to DIN EN 45545-2 R26 |
| Housing base | plastic |
| Housing material | PA/metal with epoxy powder coating |
| Hysteresis | H | typ. 5 % |
| Information for connection | A maximum of two conductors with the same core cross section may be mounted on one terminal connection! tightening torque 1.2 Nm + 10 % |
| Installation | flush |
| Length | 118 mm |
| Mass | 225 g |
| Maximum core cross-section | without wire end ferrules 2.5 mm 2 , with connector sleeves 1.5 mm 2 |
| Minimum core cross-section | without wire end ferrules 0.5 mm 2 , with connector sleeves 0.34 mm 2 |
| Mission Time (T M ) | 20 a |
| MTTF d | 670 a |
| Note | Tightening torque: 1.8 Nm (housing) |
| Output polarity | DC |
| Output type | NPN |
| Rated operating distance | s n | 20 mm |
| Reduction factor r 304 | 0.77 |
| Reduction factor r Al | 0.34 |
| Reduction factor r Brass | 0.43 |
| Reduction factor r Cu | 0.32 |
| Reduction factor r St37 | 1 |
| Reverse polarity protection | reverse polarity protected |
| Sensing face | PA-GF35 |
| Short-circuit protection | pulsing |
| Standards | EN IEC 60947-5-2 |
| Standards EN IEC 60947-5-2 Fire protection requirements of hazard level 1 to 3 (HL1 - HL3) according to DIN EN 45545-2 R26 | Standards | EN IEC 60947-5-2 | Fire protection | requirements of hazard level 1 to 3 (HL1 - HL3) according to DIN EN 45545-2 R26 |
| Switching function | complementary |
| Switching state indicator | LED, yellow |
| UL approval | cULus Listed Load Type: General Purpose Circuitry: Class 2 Power Source Enclosure Type Rating: Type 1 Supply/Switching Voltage: 60 V DC Output Switching Current: 200 mA |
| Width | 40 mm |
Изображения
Документы
К этому компоненту пока не привязаны документы.