8-Pin µSiL Package(SIL0008C To…

TPS82140SIL

IC REG BUCK ADJ 0.9V-6V 2A 8-MICROSIP

TPS82140SIL is a 17-V input, 2-A output step-down converter MicroSiP module in a 3.0 mm x 2.8 mm x 1.5 mm package, integrating an inductor, with 0.9-V to 6-V adjustable output and DCS-Control topology.Checked against the datasheet

See alternatives Ask AI FAEDatasheet PDF

All alternatives

View full report

1 alternatives on file. Sign in to view them.

Technical parameters

Key specs

Input voltage3 ~ 17 V

Output voltage900 mV ~ 6 V

Output current2 AMax

Datasheet-verified parameters

19 items

Parameter	Value and test conditions	Source
Input voltage range	3 V to 17 V
Output voltage	0.9 V to 6 V
Output current	2 A
Package	μSiL (8), 3.0 mm x 2.8 mm x 1.5 mm
Operating temperature	-40°C to 125°C
RoHS	Yes
Quiescent current	20 µA (Operating, Power Save Mode)
Switching frequency	2.0 MHz (Nominal, PWM mode)
Absolute Maximum Ratings - Input Voltage	Min: -0.3 V, Max: 20 V
Absolute Maximum Ratings - Output Voltage	Min: 0 V, Max: 7 V
Recommended Operating Conditions - Input Voltage	Min: 3 V, Max: 17 V
Recommended Operating Conditions - Output Voltage	Min: 0.9 V, Max: 6 V
Recommended Operating Conditions - Output Current	Min: 0 A, Max: 2 A
Recommended Operating Conditions - Module Operating Temperature	Min: -40°C, Max: 110°C (for 100,000 hours lifetime)
Storage temperature	Min: -55°C, Max: 125°C
Protection features	Thermal Shutdown Protection, Power Good Output
Topology	DCS-Control™
Duty cycle	100% (Lowest Dropout)
Number of pins	8

All parameters (8)ExpandCollapse

Power
Input Voltage	3 V to 17 V
Output Current	2 A
Output Voltage	0.9 V to 6 V
Quiescent Current	20 µA
AC and DC characteristics
Switching Frequency	2.0 MHz
Environment and package
Body Size	3.0 mm x 2.8 mm x 1.5 mm
Operating Temperature Range	-40°C to 125°C
Package	MicroSiP (8)

Pinout and package

Pin	Name	Function	Source
1		EN, Enable pin. Pull High to enable the device. Pull Low to disable the device. Internal pull-down resistor of typically 400kΩ when disabled.
2		VIN, Input pin.
3		GND, Ground pin.
4		VOUT, Output pin.
5		VOUT, Output pin.
6		FB, Feedback reference pin. An external resistor divider connected to this pin programs the output voltage.
7		PG, Power good open drain output pin. A pull-up resistor can be connected to any voltage less than 6V. Leave it open if it is not used.
8		SS/TR, Soft startup and voltage tracking pin. An external capacitor connected to this pin sets the internal reference voltage rising time.

Documents

DatasheetDatasheet · 753.9 KB · 2026-10-26

Open document center

Datasheet-verified content is extracted by AI from the manufacturer datasheet. Click a page number to view the original.