All alternatives
View full reportTechnical parameters
| Power | |
|---|---|
| Pulse withstand voltage | 4 kV |
| Rated insulation voltage | 300 V |
| Environment and package | |
| Ambient temperature | 5 ... 70 °C (41 ... 158 °F) |
| Storage temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Other | |
| Altitude | ≤ 2000 m above MSL |
| CCC approval | Certified by China Compulsory Certification (CCC) |
| Construction type | ball design |
| Contact loading | 250 V AC/3 A; 150 V DC/0.25 A resistive load; 60 V DC/1 A resistive load |
| Degree of protection | IEC 60529:2001 |
| Density | ≥ 0.6 g/cm 3 |
| Description | microswitch with switching ball, change-over contact |
| Directive 2014/35/EU | EN 60947-5-1:2004 + Cor.:2005 + A1:2009 |
| Directive 2014/35/EU EN 60947-5-1:2004 + Cor.:2005 + A1:2009 | Directive 2014/35/EU | EN 60947-5-1:2004 + Cor.:2005 + A1:2009 |
| Electrical life | ≥ 5 x 10 4 switching cycles |
| Equipment architecture | This device may be used with any sequential circuit, as long as the circuit can support the electrical circuit values of the switching elements. |
| Installation instructions | range of application and minimum length between mounting and float: ≥ 100 mm (4 inch), preferred for fuels, heating oils, oily fluids mounting: The float switch is mounted by means of a counter weight or rods (e. g. float switch combination) from the top. The pivot of the cable should always be horizontal. |
| Length | L | 10 m |
| Length L 10 m | Length | L | 10 m |
| Material | float: PP (Polypropylene) cable: PUR, highly flexible (3 x 0.50 mm 2 ) |
| Process pressure (static pressure) | ≤ 2 bar (29 psi) at 20 °C (68 °F) |
| Process pressure (static pressure) ≤ 2 bar (29 psi) at 20 °C (68 °F) Density ≥ 0.6 g/cm 3 | Process pressure (static pressure) | ≤ 2 bar (29 psi) at 20 °C (68 °F) | Density | ≥ 0.6 g/cm 3 |
| Series | LFL2-**-U |
| Supplementary information | Statement of Conformity, Declaration of Conformity, Attestation of Conformity and instructions have to be observed where applicable. For information see www.pepperl-fuchs.com. |
| Switching point | switch angle, measured against the horizontal: - upper switch point 25° ±10° - lower switch point 6° ±6° |
Documents
No documents are linked to this part yet.