All alternatives
View full reportTechnical parameters
| Power | |
|---|---|
| No-load supply current | I 0 | ≤ 20 mA |
| Off-state current | I r | 0 ... 0.5 mA |
| Operating current | I L | 0 ... 200 mA |
| Operating voltage | U B | 10 ... 30 V DC |
| Operating voltage indicator | LED, green |
| Rated insulation voltage | U BIS | 50 V |
| Voltage drop | U d | ≤ 3 V |
| AC and DC characteristics | |
| Switching frequency | f | 0 ... 50 Hz |
| Time delay before availability | t v | ≤ 300 ms |
| Environment and package | |
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Height | 40 mm |
| Height 40 mm Width 80 mm Length 80 mm | Height | 40 mm | Width | 80 mm | Length | 80 mm |
| Temperature drift | ± 10 % at 0 ... 50 °C (32 ... 122 °F) ± 20 % at -25 ... 0 °C (-13 ... 32 °F) and 50 ... 70 °C (122 ... 158 °F) |
| Other | |
| Assured operating distance | s a | 0 ... 55 mm |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Connection type | screw terminals |
| Core cross section | up to 2.5 mm 2 |
| Degree of protection | IP68 |
| Diagnostic Coverage (DC) | 0 % |
| Housing base | aluminum painted |
| Housing material | PBT |
| Hysteresis | H | typ. 3 % |
| Information for connection | A maximum of two conductors with the same core cross section may be mounted on one terminal connection! tightening torque 1.2 Nm + 10 % |
| Installation | non-flush |
| Length | 80 mm |
| Maximum core cross-section | without wire end ferrules 2.5 mm 2 , with connector sleeves 1.5 mm 2 |
| Minimum core cross-section | without wire end ferrules 0.5 mm 2 , with connector sleeves 0.34 mm 2 |
| Mission Time (T M ) | 20 a |
| MTTF d | 824 a |
| Output polarity | DC |
| Output type | PNP |
| Rated operating distance | s n | 75 mm |
| Reduction factor r 304 | 1 |
| Reduction factor r Al | 1 |
| Reduction factor r Cu | 1 |
| Reduction factor r St37 | 1 |
| Reverse polarity protection | reverse polarity protected |
| Sensing face | PBT |
| Short-circuit protection | pulsing |
| Standards | EN IEC 60947-5-2 |
| Standards EN IEC 60947-5-2 | Standards | EN IEC 60947-5-2 |
| Switching function | complementary |
| Switching state indicator | LED, yellow |
| UL approval | cULus Listed Load Type: General Purpose Circuitry: Class 2 Power Source Enclosure Type Rating: Type 1 Supply/Switching Voltage: 30 V DC Output Switching Current: 200 mA |
| Width | 80 mm |
Documents
No documents are linked to this part yet.