TXS0101-Q1
在产This one-bit non-inverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.2V to 3.6V. VCCA may be greater than or equal to VCCB as long as VCCA is less than 3.6V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65V to 5.5V. This allows for low voltage bidirectional translation between any of the 1.8V, 2.5V, 3.3V, and 5V voltage nodes. When the output-enable (OE) input is low, all outputs are placed in the high-impedance state. To put the device in the high-impedance state during power up or power down, tie OE to GND through a pull-down resistor; the current-sourcing capability of the driver determines the minimum value of the resistor.
全部替代型号
查看完整报告技术参数
| 电源 | |
|---|---|
| Supply current (max) (mA) | 0.025 |
| 交流 / 直流特性 | |
| Prop delay (ns) | 165 |
| 环境与封装 | |
| Operating temperature range (°C) | -40 to 125 |
| 其他 | |
| Applications | GPIO |
| Bits (#) | 1 |
| Data rate (max) (Mbps) | 50 |
| Direction control (typ) | Auto-direction |
| Features | Edge rate accelerator, Output enable, Partial power down (Ioff), Vcc isolation |
| Rating | Automotive |
| Technology family | TXS |
| Topology | Open drain, Push-Pull |
| Vin (max) (V) | 3.6 |
| Vin (min) (V) | 1.2 |
| Vout (max) (V) | 5.5 |
| Vout (min) (V) | 1.65 |