TXB0108-Q1
在产This 8-bit noninverting translator uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.2V to 3.6V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.65V to 5.5V. This allows for universal low-voltage bidirectional translation between any of the 1.2V, 1.5V, 1.8V, 2.5V, 3.3V, and 5V voltage nodes. VCCA should not exceed VCCB. When the output-enable (OE) input is low, all outputs are placed in the high-impedance state. The TXB0108-Q1 is designed so that the OE input circuit is supplied by VCCA. This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. To ensure the high-impedance state during power-up or power-down, OE should be tied to GND through a pulldown resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver.
全部替代型号
查看完整报告技术参数
| 电源 | |
|---|---|
| Supply current (max) (mA) | 0.011 |
| 交流 / 直流特性 | |
| Prop delay (ns) | 4 |
| 环境与封装 | |
| Operating temperature range (°C) | -40 to 125 |
| 其他 | |
| Applications | GPIO, I2S, JTAG, PCM, SPI, UART |
| Bits (#) | 8 |
| Data rate (max) (Mbps) | 100 |
| Direction control (typ) | Auto-direction |
| Features | Edge rate accelerator, Output enable, Partial power down (Ioff), Vcc isolation |
| Rating | Automotive |
| Technology family | TXB |
| Topology | Push-Pull |
| Vin (max) (V) | 3.6 |
| Vin (min) (V) | 1.2 |
| Vout (max) (V) | 5.5 |
| Vout (min) (V) | 1.65 |