全部替代型号
查看完整报告技术参数
| 电源 | |
|---|---|
| No-load supply current | I 0 | ≤ 20 mA |
| Off-state current | I r | 0 ... 0.5 mA typ. 0.01 mA |
| Operating current | I L | 0 ... 200 mA |
| Operating voltage | U B | 10 ... 30 V DC |
| Operating voltage indicator | LED, green |
| Rated impulse withstand voltage | U imp | 2.5 kV |
| Rated insulation voltage | U i | 230 V |
| Rated insulation voltage U i 230 V Rated impulse withstand voltage U imp 2.5 kV | Rated insulation voltage | U i | 230 V | Rated impulse withstand voltage | U imp | 2.5 kV |
| Voltage drop | U d | ≤ 2 V |
| 交流 / 直流特性 | |
| Switching frequency | f | 0 ... 100 Hz |
| Time delay before availability | t v | 120 ms |
| 环境与封装 | |
| Ambient temperature | -25 ... 85 °C (-13 ... 185 °F) |
| Height | 55 mm |
| Height 55 mm Width 55 mm Length 128 mm | Height | 55 mm | Width | 55 mm | Length | 128 mm |
| 其他 | |
| Actual operating distance | s r | 36 ... 44 mm |
| Assured operating distance | s a | 0 ... 32.4 mm |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Connection type | screw terminals |
| Core cross section | up to 2.5 mm 2 |
| Degree of protection | IP68 / IP69K |
| Diagnostic Coverage (DC) | 0 % |
| Housing base | plastic |
| Housing material | PA/metal |
| Hysteresis | H | typ. 5 % |
| Information for connection | A maximum of two conductors with the same core cross section may be mounted on one terminal connection! tightening torque 1.2 Nm + 10 % |
| Installation | non-flush |
| Length | 128 mm |
| Mass | 225 g |
| Maximum core cross-section | without wire end ferrules 2.5 mm 2 , with connector sleeves 1.5 mm 2 |
| Minimum core cross-section | without wire end ferrules 0.5 mm 2 , with connector sleeves 0.34 mm 2 |
| Mission Time (T M ) | 20 a |
| MTTF d | 1310 a |
| Note | Tightening torque: 1.8 Nm (housing) |
| Output polarity | DC |
| Output type | PNP |
| Protection class | II |
| Rated operating distance | s n | 40 mm |
| Reduction factor r 304 | 0.75 |
| Reduction factor r Al | 0.39 |
| Reduction factor r Brass | 0.45 |
| Reduction factor r Cu | 0.37 |
| Reverse polarity protection | reverse polarity protected |
| Sensing face | PA |
| Short-circuit protection | pulsing |
| Standards | EN IEC 60947-5-2 |
| Standards EN IEC 60947-5-2 | Standards | EN IEC 60947-5-2 |
| Switching function | Normally open (NO) |
| Switching state indicator | LED, yellow |
| UL approval | cULus Listed Load Type: General Purpose Circuitry: Class 2 Power Source Enclosure Type Rating: Type 1 Supply/Switching Voltage: 30 V DC Output Switching Current: 200 mA |
| Width | 55 mm |
器件图片
技术资料
该型号暂未收录资料。